weberfloor base rapid 4360
Packaging
- 25kg
Rapid drying, self-smoothing base and renovation screed suitable for residential, commercial and industrial areas.
weberfloor base rapid 4360 is a rapid drying, self-smoothing base and renovation screed — sometimes also referred to as a self levelling compound or self levelling screed — which can be applied to depths of 20-80mm used for levelling:
- Concrete
- Sand/cement screeds
- Anhydrite screeds
- Wooden boards
- Underfloor heating/warming
- Insulation boards
- Existing tiles
- Bitumen
weberfloor base rapid 4360 is suitable for covering with:
- Tiles
- weberfloor smooth 4150 thin topping screed
- weberfloor smooth rapid 4160 thin topping screed
- weberfloor industry pro top 4610 industrial topping screed
Suitable for use in residential, commercial and industrial areas, light foot traffic is possible after 2-3 hours in normal conditions, tiling is possible after 12hrs and final floor coverings other than tiles can be applied after 1-7 days depending on layer thickness and drying conditions.
- For application depths between 20-80mm
- Weber Low Dust TechnologyTM improves comfort of applicators
- Pump or hand applied
- Rapid drying
- Foot traffic after 2-3 hours
- Tile after 12 hours
- Final floor covering installed after 1-7 days in normal conditions
- Ideal for correcting highly irregular substrates
- Low alkalinity
- Casein-free
- Low emissions
- Cannot be used on external projects
- Must not be used as a wearing screed — either be directly tiled over or prior to receiving a soft floor covering cover with a thin layer of either weberfloor smooth 4150 or weberfloor smooth 4160
- When stored unopened in a cool, dry place at temperatures above 5°C, shelf life is 12 months from date of manufacture
- Please refer to relevant building regulations prior to the installation of weberfloor products
| Temperature of application | +10°C to +25°C |
| Minimum substrate strength | 1N/mm² (residential and commercial areas) 1.5N/mm² (industrial areas) |
| Minimum thickness | 20mm |
| Minimum Thickness (underfloor heating) | >25mm over the heating pipes |
| Minimum Thickness (over slip membrane solid substrate) | 30mm |
| Minimum Thickness (floating floor) | 35mm (with weberfloor 4945 fibre mesh) |
| Maximum thickness | 80mm |
| Water addition | 4.5 litres/25kg (18%) |
| Compressive Strength | C30 |
| Flexural Strength | F 6 |
| Shrinkage | <0.05% |
| Flow Rate | 180-210mm |
| Approx. material consumption | 1.85kg/m2 /mm |
| Hardening time (before foot traffic) | 2-3 hours in normal conditions |
| Hardening time (before tiling) | 12 hours in normal conditions |
| Hardening time (before final covering) | 1-7 days depending on layer thickness and drying conditions |
| Pot life | 20 |
