weberfloor DPM Pro NEW
weberfloor DPM Pro
Two-component epoxy based damp proof membrane capable of one coat application.
Packaging
- 10kg
- 20kg
Two-component epoxy based damp proof membrane that is capable of being applied in one coat, dependent upon the condition of the substrate and quality of workmanship to ensure full coverage is achieved at the required thickness.
weberfloor DPM Pro can be applied on to concrete or cement based screed surfaces with a moisture content of up to 98% RH (measured using a hygrometer) when installed in accordance with Weber recommendations, to facilitate early overlay of moisture sensitive finishes.
- For application onto concrete and cement based substrates
- Suppresses the passage of residual construction moisture up to 98% RH when full coverage is achieved
- Capable of one coat application
- Easy to apply
- Reduces project timescales allowing early installation of floor finishes
- Suitable for substrate up to 98% RH
- Accelerates project timelines
- weberfloor screed and smoothing compounds can be applied in as little as 3 hours
- Not to be left uncovered by a suitable weberfloor product
- Application characteristics are affected below 10°C, minimum application temperature of 5°C
- Humidity levels of the substrate must be checked with a hood hygrometer to ensure suitability prior to application of weberfloor DPM Pro
- Not suitable for substrates without a structural damp proof membrane – weberfloor DPM Pro is only designed to suppress residual construction moisture
- Surfaces should have a minimum pull-off strength of 1MPa for commercial or residential areas and 1.5MPa for industrial areas
