weberfloor resin finish system is a durable, high precision system ideal for use where a resin finish is required. The system has been designed to receive a resin coating in as little as 24 hours. This system should be applied fully bonded, with the optional addition of a base coat where weak substrates first need to be made good.
weberfloor resin finish system
Durable industrial flooring system with a high-precision finish designed to be covered with a decorative resin.
Suitability
- Suitable for concrete, cementitious and anhydrite substrates
- Moisture control system weberfloor DPM is required for substrates with a moisture content of up to 98% RH (measured using a hygrometer)
Application
- Floor screeds (weberfloor base rapid 4360 and weberfloor industry rapid 4655): Applied by machine or hand
- Primer (weberfloor 4716): Applied by hand using a soft brush or spray
- Moisture control system (weberfloor DPM): Applied by hand using a medium pile roller
Curing times
- After 2 hours: Suitable for foot traffic
- After 24 hours: Suitable for light industrial traffic
- After 1 week: Suitable for full industrial traffic
Final finish
- Super flat and smooth finish minimises wear and enables high storing shelves
- Very high durability towards mechanical stress means long lifetime
- Compatible resin finishes approved by Weber include KDR EpoCoat WD Coloured, KDR EpoCoat HB, and KDR DekFlex Gripcoat
- If substrate is in need of repair please see weberfloor substrate repair system
- Cannot be used on external projects
- Substrate must have a pull-off strength ≥1.5MPa
- Consideration should be given to the requirements of the resin finish when deciding if weberfloor DPM is required