weberend MT panel silicone system

weberend MT panel silicone system is designed for application onto an appropriately-framed calcium silicate panelled background.

Applied with weberend LAC rapid resin-rich adhesive render coat and strengthened with glass-fibre weber standard meshcloth, this system doesn't require the use of primers, saving time lost waiting for primers to dry.

Water resistant webersil TF is used as the final finish to provide a silicone textured finish available in a wide range of over 100 colours.

Use multiple finishes on the same project

This system can be used in conjunction with the weberend MT panel brick system for building designs which require a mix of brick and render finishes.

Final façade finish:

• Finished with webersil TF silicone textured finish with enhanced water resistance and available in over 100 colours.

Reaction to fire:

• A2-s1,d0 reaction to fire classification in accordance with BS EN 13501. Extended application report on request.

Certification & requirements:

• BBA approved for the following render carrier boards (scroll down for BBA certificates):
  • Glasroc X
  • Knauf Aquapanel Exterior
  • Siniat Bluclad
• Accepted by the NHBC in relation to NHBC Standards

Suitability:

• Large areas can be rendered on calcium silicate panels without the need for expressed joints.
• Strengthened with glass-fibre weber standard meshcloth.
• Factory batched materials for consistency.
• Please refer to the table below for information on BBA certification and suitability for different building heights:

Fixing recommendations:

Prior to installation please contact compatible substrate board manufacturer to obtain fixing recommendations and ensure board suitability when withstanding necessary wind load requirements for your specific project.

Do not apply:

• If frost is forecast within 24 hours of use.
• In damp/wet conditions.
• In temperatures below 5°C or above 30°C.
• On elevations in direct sunlight or where the substrate is hot.